The Radial Engineering Reamp HP is the ultimate tool for producers and mixing engineers looking to save time reamping. Designed to receive a signal from your interface's headphone output, users can easily send bass and guitar tracks to it without disconnecting cables. If you've been searching for a simple tool to take your mixing sessions to the next level, you need to check out the Reamp HP!
Using the Reamp HP is dead simple-just send it the desired track via the headphone output on your audio interface, and you'll be all set to experiment with different tones and effects. Users can then adjust the level of the signal and can engage the ground lift switch to eliminate any hum or buzz.
With the Reamp HP, users also have the flexibility to send stereo tracks and sum them down by using the device's dedicated mono switch. Additionally, this unit features a 1/4" and a 3.5mm input, so producers can reamp tracks from a variety of different sources aside from an audio interface. Have a guitar, bass, or vocal track stored on your smartphone or tablet? No worries, just send it a signal via the 3.5mm input, and you'll have easy access to studio-grade reamping.
Complete with a heavy-duty enclosure and an isolation transformer that allows for low-noise recordings, the Radial Engineering Reamp HP is a must-have for producers and audio engineers seeking an incredibly efficient studio reamper.
Audio circuit type: Passive, transformer isolated
Frequency response: 20Hz ~ 20KHz (+/- 0.5dB)
Dynamic range: >96dB
Total harmonic distortion: 0.0015% @1kHz
Input Impedance: 11.8kΩ
Output Impedance: 1.5kΩ
Equivalent Input Noise: -105dBu
Maximum Input: >+20dBu
Features: Mono Sum, Ground lift, Level Control
Input Connectors: ¼" TRS unbalanced stereo, 3.5mm TRS unbalanced stereo
Output Connectors: ¼" TS
Construction: 16 gauge steel chassis and outer shell
Size (L x W x D): 4.6" x 1.50" x 1.89" (117mm x 48mm x 38mm)
Weight: 0.58 lbs (256g)
Power: Passive, no power required
Conditions: For use in dry locations only between 5°C and 40°C