Walrus Audio Fathom Multi-Function Reverb - Limited Santa Fe Series


We're sorry. This item is no longer in stock.


Walrus Audio's all-new Santa Fe series of pedals features limited edition artwork inspired by the rich sunsets of Santa Fe, New Mexico.

The Fathom is an incredibly flexible new reverb pedal from Walrus Audio. With a multitude of reverb modes, you can turn your dry guitar signal into a flood of dripping wet tones! Between the classic Hall and Plate reverbs to the wild Lo-Fi and Sonar 'verbs that takes your tones into uncharted depths sonically. A truly impressive reverb pedal that holds true to the classic reverb sounds while still pushing the bounds of new reverb tones!

From Walrus Audio:
The Fathom is a feature-rich reverb with 4 different customized reverb algorithms to choose from. Easily go from tasteful, small room reverb to long, modulated trails dripping of ambient goodness. The toggle switch adds options for low, medium and high modulation. Use the dampen knob to fine tune the tone of the reverb's decay.

The Fathom features 4 different algorithms.
-Hall: Wide, open and vast with decay that ends with high-frequency roll off. X knob adjusts pre-delay.
-Plate: Full Body reverb with a smooth decay. X knob adjusts pre-delay.
-Lo-Fi: Filtered reverb with decay ranging from warm, to thin AM-sounding radio. X knob adjusts filter width.
-Sonar: Reverb fed with both a high and low octave with the ability to blend the octaves with the X knob.

Momentary Functions: When the pedal is in its off position, you can then press and hold the Bypass Switch to temporarily activate the effect to add a moment of reverb. Releasing the switch turns the effect off.
Press and hold the Sustain Switch while the pedal is on, to sustain the reverb decay for a dreamy ambient decrescendo.
Trails Mode: To turn trails mode on or off, unplug the pedal and press and hold down the Bypass Switch for two seconds while plugging the pedal back in.

The diecast enclosure's exact size is 4.77" x 2.6" x 1.39". Power requirements are 9VDC (100mA minimum).
The use of an isolated power supply is recommended for powering all Walrus Audio Pedals. Daisy chain power supplies are not recommended. Power supply not included.